I’d say your chances are very good. Even their high end rackmount models work with the usbhid-ups driver. Don’t think they would change things up in this regard since they would also need to change their software.
I’d say your chances are very good. Even their high end rackmount models work with the usbhid-ups driver. Don’t think they would change things up in this regard since they would also need to change their software.
The port is forwarded from your router to the pi, right? If so, you could test for the router as the bottleneck using the router’s WAN side IP address as the target.
This should give you a good data point for comparison. If it’s also slow then you can focus on the router performance. Some are slow when doing hairpin NAT.